0:00
There's a good chance my till and trim was in water
0:02
I'm concerned that I might find some corrosion inside the pistons. You mentioned that not a lot truly goes bad on these, but I'm curious what would give
0:10
you pause on the internals apart from what you mentioned about the rams being nicked
0:14
So again, we're talking about trim units. The inside, if you get water inside the unit, like I said, there's not a lot that goes bad
0:20
in them. There are little balls inside of the trim unit with springs behind them
0:25
They are valves basically. They're, you know, they're passageways. And if you have water inside the trim unit, then those can rust because now you have these
0:34
metal components, their springs and little balls that are polished to fit in an orifice
0:38
and you know, block fluid to run in different directions based on how you're trying to operate
0:43
the trim unit. So those would be my only concern. Other than that, getting all the water out of it and filling it up
0:49
That's kind of the basic concerns with a trim unit
