0:00
Been getting water in my lower unit for about three months
0:03
The lower water pump base seal had a tear in it, so figured that was my problem
0:09
Replaced it new and the upper water pump, well, all new. Put new oil in it, run it for about six hours of fishing
0:17
drain the oil when I got home, had a gray, greenish look to it
0:21
I don't know any ideals. Got a bunch going on here, Slave. We just did a video about this a few weeks ago
0:28
By the time this podcast comes out and talking about all the different places
0:32
that a lower unit can take in water. Now, if you've got greenish, grayish water
0:36
so gray is not good. Gray is metal. That means that you are grinding something
0:42
and if you've got gray, that's a problem. Now, as far as greenish
0:47
I'm guessing you put merc gear lube in there, and that's why it's a greenish color
0:53
If not, then that's a whole other topic right there, being the color of the gear lube
0:58
But for one, you do have a leak somewhere, and for two, you possibly have some metal on metal
1:02
with the gray. The thing that you need to do is pressure test it
1:07
because there's a whole bunch of different, there's seven different ways that you can take on water
1:12
to the lower unit. You've got your shift shaft seal, you've got your drive shaft seal
1:16
you've got your prop shaft seals, you've got drain plug, the vent plug
1:21
the O-ring on the bearing carrier for the prop shaft bearing carrier
1:25
and then the O-ring on the drive shaft bearing carrier. So you really need to pressure test it
1:31
Just finding a cut on the water pump base gasket is not really, the water pump base gasket
1:37
is more for your water pressure and the amount of water that's going up to the engine
1:45
If you've got tears in the water pump housing O-ring or the water pump base gasket
1:52
these are things that like, make sure that the water in your water pump
1:56
is being forced up and not able to leak out, back down into the water
2:01
into the lower unit, anywhere else. It does not really have anything to do
2:05
with water getting inside of the gear case. So you're going to need to drain the lower unit
2:13
and then put your drain plug in and put a pressure tester on there
2:18
pump it up to like 10, 12 PSI and then take a water bottle
2:24
or I mean a squirt bottle of degreaser, soapy water, anything like that. Spray it around again
2:29
shift shaft, drive shaft, prop shaft, and turn the shafts as you are spraying them
2:36
with that pressure in the gear case. And you should start to see air bubbles
2:40
coming out from one of those locations. If you do not see any air bubbles
2:44
then most likely the O-ring down around the prop shaft bearing carrier is what's leaking
2:49
but you're going to have to pressure test it. There's no way to get around it
2:54
You've got to do a pressure test in order to figure out where that gear lube
3:00
is getting out and water is getting in. Hope that helps. Pressure tester, you know
3:05
any kind of a pump that's going to create pressure, you only need 10 PSI, 12 PSI
3:11
So I would suggest getting one from Amazon or from Harbor Freight, somewhere cheap
3:17
If you need to pressure test a gear case a lot, I would go with the Stevens
3:22
but the Stevens are like 180 bucks. Now, if you enjoyed this clip, you can watch the full episode over here
3:26
or you can watch another one over here