0:00
This is a wireless charger and what we're going to do is mount this biscuit right here on this boat
0:06
so that way we can charge our phone on the boat. Bang perfect. So let me open this thing up so you
0:11
can see what it is. This is a Scanstrut Rock wireless nano 10 watt. This is actually the
0:19
side version here. Pop this thing out here. So this thing you put it in goes to the side, clip your phone in there and it'll charge it up
0:31
Works really really good. These things are super simple to put in. Boom. Now we just need to hook
0:37
this up to power so that we can put this charger. We're actually going to be mounting this thing
0:44
right here because we had a spotlight controller that was there. Now we're going to be covering
0:49
that up like that so this will be something like that. A little bit up a little bit just so it'll
0:55
look nice. You'll be running along charging your phone playing your music. So what we're going to
1:01
do is get a plate made for this, put the plate on, mount this to the plate and then we need to wire
1:07
this thing up to power. They've actually also got this one which is like a vertical mount so
1:12
you got two different orientations. In this application we're going to be putting this one
1:18
on there. Sike! Now we're going to be powering this phone charger since it doesn't use a whole lot. We're going to be
1:55
powering this thing from our breakers and switches that's in here because if we look up here just to
2:03
as an example that bar right there is pretty much the only fuse panel and that thing is stacked
2:11
It's also ran off of this solenoid right here which is activated by a switch but then in here
2:18
everything else is fully packed out so there's literally no space for anything basically. So
2:26
what we're going to do is we're going to run the charger off of one of these breakers. So we're
2:31
going to take one of these off right we're going to take one of these off and we're going to put
2:38
these spade connectors on to our thing like that. Probably need to split that up a little bit
2:49
just because of how far away the breaker is from the switch but so we'll put these spades on there
2:54
use a double and jump it off our breaker there so that way we've got circuit protection and we
3:00
got power. Just going to get that first little split and then you can roll her
3:05
I think you should be able to. Normally it just splits. There you go
3:12
How much of a split do you want? That should be enough
4:10
And here on the inside we got it all looking spiffy and you can't really tell because there's
4:15
so many wires but this is where we're hooked up we're running through this breaker so we got
4:20
circuit protection from that breaker and then we just grounded it right there zip tied our wires
4:26
and then boom right there nice seal all the way around. We got this thing all screwed down and
4:31
sealed up. It actually looks really good. I like the little logo it's a good touch but
4:37
let's give her a test here see what happens. There you go she's charging
4:45
Fits perfectly. Phone's not overhanging anything. I'd say that's pretty darn good
